The Future of Air Conditioning Systems – Part 2
Currently, air conditioning systems use nearly 30% of all energy used in U.S. commercial and residential buildings. Non-vapor-compression HVAC systems have the potential reduce our current systems by as much as 40%. With that said, the Department of Energy is spending millions to fund programs that fall into a few basic categories: advanced vapor compression technology and non-vapor compression technology.
Advanced vapor compression systems will use highly efficient versions of the technologies that currently drive HVAC systems, but uses refrigerants that will have a minimal effect on the environment. There are two projects are aimed at reducing the cost and improving the performance of air conditioning systems in buildings using refrigerants that have minimal effect on the global environment.
United Technologies Research Center (UTRC) (East Hartford, Connecticut) will demonstrate a high efficiency centrifugal compressor design that will enable high efficiency small commercial rooftop systems in the 1.5- to 10-ton range, as compared to units operating in the 50-ton range. These systems could provide 30% annual energy savings with less than two years payback by 2020, and if fully commercialized, could save 2.5 quads of energy by 2030.
Mechanical Solutions, Inc. (MSI) (Whippany, New Jersey) and Lennox Industries, Inc. (Lennox) (Richardson, Texas) will develop an HVAC system featuring a small centrifugal compressor that is highly efficient. This project will initially focus on improving residential HVAC, which typically use 4-5 ton systems, and could eventually be scaled up to commercial systems as large as 20 tons.
Non-vapor compression systems will employ new technologies that use refrigerants that don’t effect the environment. There are five projects that are aimed at developing next-generation HVAC systems, which unlike current vapor compression HVAC systems, will not use HFCs (hydrofluorocarbons) in refrigerants that harm the global environment.
Dais Analytic (Odessa, Florida) will advance membrane HVAC technology that will use nanostructured polymer materials (membrane) to manipulate water molecules, allowing the system to condition air while improving energy efficiency and eliminating fluorocarbon refrigerants. The project will result in a rooftop-capable system for field testing.
Maryland Energy and Sensor Technologies, LLC (MEST) (College Park, Maryland) will develop a compact thermoelastic cooling (TEC) system with high efficiency, low environmental impact, and a small carbon footprint. TECs work by stretching and then relaxing metal rods, creating heat, but cooling rapidly when released. The alternation between the two states performs the same task as a heat pump compressor. Currently, TEC requires a large mechanical loading system, which results in high materials cost. MEST will solve this problem by reducing system size by a factor of 10.
Oak Ridge National Laboratory (Oak Ridge, Tennessee) will develop a novel magnetocaloric air conditioner with the potential for efficiency improvements of up to 25% over conventional vapor compression systems, equivalent to saving 1 quad of energy annually for space heating and cooling in the U.S. residential sector. The system moves copper, brass or aluminum rods in and out of a magnetic field that is produced by passing electricity through a copper coil. The temperature of the rods drops when they are within the magnetic field. The rods absorb heat, which is transferred to the outside when the rods are removed from the magnetic field. The concept window air conditioner produces electricity through a magnetic field and could possibly be scaled up to larger systems.
United Technologies Research Center (UTRC) (East Hartford, Connecticut) will demonstrate an electrocaloric heat pump that will be 50% smaller than current models, run more quietly and likely cost less to maintain because of its simple mechanical design. If fully commercialized, the heat pump could result in annual energy savings of more than 1.5 quads and reduce greenhouse gas emissions by 60 million metric tons.
Xergy, Inc. (Seaford, Delaware) will develop electrochemical compression (ECC) technology in combination with an energy recovery module to replace a solid-state compressor for use in heat pumps. ECC uses fuel cell technology to enable heat pumps to use water as the refrigerant. Thermodynamic modeling shows efficiency improvements of 30-56% are attainable in a commercial system. The project seeks to produce a unit with a 5-year or better payback period when produced at commercial scale.
The Energy Department’s Office of Energy Efficiency and Renewable Energy (EERE) accelerates development and facilitates deployment of energy efficiency and renewable energy technologies and market-based solutions that strengthen U.S. energy security, environmental quality, and economic vitality. EERE supports innovative technologies that reduce both risk and costs of bringing energy efficient building technologies online.
ABC Air Conditioning & Heating Specialist in Orlando
ABC Air Conditioning & Heating Specialist in Orlando is known for being a company that genuinely cares about people and values their business. Our services include: Orlando Air Conditioning Service, Orlando Air Conditioning Installation, Orlando Air Conditioning Repair, Orlando Heating Service, Orlando Heating Installation & Orlando Heating Repair. Our commitment to service is why customer referrals are our number one source of new business. If you are looking for a quality HVAC repair company in the Orlando area, ABC Air Conditioning & Heating Specialist, Inc. is the company for you. Please call us at (407) 282-2280 today.
Learn more about the Department’s efforts to help homes and buildings save energy.